Centrifugal Casting of High Speed Steel/Nodular Cast Iron Compound Roll Collar

Ｈｉｇｈ ｓｐｅｅｄｓｔｅｅｌ (ＨＳＳ) ,ｉｓｃｈａｒａｃｔｅｒｉｚｅｄｂｙｅｘ ｃｅｌｌｅｎｔｈａｒｄｎｅｓｓ ,ｗｅａｒｒｅｓｉｓｔａｎｃｅ ,ａｎｄ ｇｏｏｄｒｅｄｈａｒｄｎｅｓｓ .Ｒｅｃｅｎｔｌｙ ,ＨＳＳｉｓａｐｐｌｉｅｄｔｏｍａｎｕｆａｃｔｕｒｅｈｏｔｒｏｌｌｉｎｇｒｏｌｌｓｔｏｐｒｏｄｕｃｅｓｔｒｉｐｓｏｆｇｏｏｄｓｈａｐｅａｎｄｓｍａｌｌｃｒｏｗｎｗｉｔｈｅｘｔｅｎｄｅｄｒｏｌｌｓｅｒｖｉｃｅｌｉｆｅ[1,2 ] .ＴｈｅＨＳＳｉｓａｐｐｌｉｅｄｔｏｍａｎｕｆａｃｔｕｒｅｒｏｌｌｃｏｌｌａｒｆｏｒ…     

露天矿山牙轮钻机主参数确定探讨

通过对牙轮钻、轴压、钻头速度、排碴风量、排碴风压的论述得出了如何调定牙轮钻的参数，为以后我矿牙轮钻在生产中获取最大经济效益积累了有益的资料。     

隔河岩水电厂220 kV线路保护配置及运行分析

介绍了隔河岩电厂220kV线路保护的原理设计及运行情况，以及采用了双重微机化继电保护装置后带来的优越性，简要描述了CSL-101A高频保护和RCS-931A光纤保护的应用特点。     

Scanning electron microscope electron detector with a radial type discrete dynode electron multiplier

A discrete dynode electron multiplier with radial flux of electrons was built and tested in the range of low‐voltage scanning electron microscopy as a backscattered electron detector of topographic contrast. The multiplier collects backscattered electron emitted in a specific range of take‐off angles and over the whole azimuth angular range enabling large solid collection angle. Multipliers with different dynode shapes were studied theoretically with the use of the software for particle optics and three assemblies were built and tested experimentally. The gain estimation, assessment of the type of detected electrons (secondary electron or backscattered electron), imaging the spatial collection efficiency and signal‐to‐noise measurements were performed.     

三维有限元法分析频率对接地电阻的影响

提出了用涡流场的A-V有限元分析方法计算接地系统接地电阻的方法,分析了入地电流频率的变化对接地电阻的影响。计算结果表明,频率对接地体自身电阻的影响较大,但对散流电阻的影响很小。     

低温吸附法脱除一氧化碳中甲烷的实验研究

在液氮温度下,采用吸附剂CNA X进行低温脱甲烷动态吸附实验,结果表明CNA X在液氮温度下可以将一氧化碳中0 1%左右的甲烷脱除到10×10-6。     

NiTi形状记忆合金激光气体氮化层表面特征

为改善NiTi合金的表面性能，利用2kW连续波Nd：YAG对NiTi合金进行激光气体氮化处理。采用SEM、TEM、XRD、XPS和纳米压痕研究了氮化层的显微组织及表面特征．结果表明：激光气体氮化可以在NiTi合金表面制备连续、无裂纹、厚度为2μm的TiN表面层，该表面层中基本不合有Ni元素且具有很高的硬度，其纳米压痕硬度为29．28GPa．     

KATRIN NEG pumping concept investigation

The Karlsruhe Tritium Neutrino experiment (KATRIN) is going to use a very large electro-static tandem spectrometer to measure the electron spectrum from the tritium beta decay, where several kilometers of non-evaporable getter (NEG) strips (type ST707) are to be used to achieve the UHV requirements. Different geometrical configurations of the NEG strips have been studied by Monte Carlo simulations. It is shown that the resulting pumping speed of the getter pumps will allow to get a pressure below 10⁻¹¹ mbar in the huge vessel with a volume of 1400 m³. By systematic assessment of the statistics of the pumping surfaces, it could be demonstrated that the design is sound.     

晶体硅薄膜电池制备技术及研究现状

晶体硅薄膜太阳电池近些年来得到广泛的研究和初步的商业化探索。根据所采用的晶体硅薄膜沉积工艺中温度范围的不同，晶体硅薄膜电池研究可分为高温路线和低温路线两个不同发展方向。本文分别从这两个方向综述了目前国外晶体硅薄膜电池制备技术的最新进展，最新实验室研究结果。报导了晶体硅薄膜电池商业化进展状况，指出了晶体硅薄膜电池实现产业化必须解决的问题。     

智能型MNS低压开关柜

MNS智能低压开关柜是ABB公司的新一代产品。除具有设计灵活、结构紧凑和免维护等特点外，安全可靠性是其最突出的优点，包括抗故障电弧、可靠的绝缘分隔及接插性能、可靠的抽屉单元和温升限制。采用和智能化电动机控制中心INSUM及配电智能化控制和能量管理系统ESD2000的完美结合，开发了了基于现场总线的智能化的系统解决方案。